Zip Inline ES6 Electronic Instantaneous 5.5kW Water Heater
The Zip Inline ES Electronic Instantaneous Water Heater is designed specifically for hand washing. The Zip Inline ES Electronic Instantaneous Water Heater from Plumbnation allows water to be heated as and when you need it.
The Zip Inline ES Instanteous Water Heater is part of the Zip Inline Water Heaters from Zip Water Heaters. Zip Inline ES Electronic Instantaneous Water Heater appliance must be installed in a frost free environment. The appliance is intended for connection to the mains water supply. It should be installed by a suitably qualified person. The appliance may be used as an unvented or vented installation.
The Zip Inline Water Heater must be earthed and connected to the supply by means of permanent wiring through suitable isolation having a contact separation of at least 3mm in all poles. Installation must comply with current IEE regulations. The cross sectional area of the connection cable must be in accordance with the power rating of the appliance.
- Water runs at the right temperature, right away; no water is heated & stored - so no energy waste, no water waste!
- Bare wire technology heats water - fast
- 5.5kW output
- Automatically adjusts to variable inlet pressure
- Switches on when minimum flow rate exceeded
- Impact resistant plastic
- Factory-set at 38C
- Energy conservation: no standing heat loss - Zip Inline ES heats water as required!
Deciding on the most suitable type of Water Heater is a major decision. When you decide that
Instantaneous Water Heaters give the appropriate solution then the Zip ES6 is without doubt worth putting on the shortlist.
